New building †Tools and Wiring Essay Example for Free

New building Tools and Wiring EssayNow that we understand the codes and standards implyed to create this building, its judgment of conviction to put stuff in it. Our task at hand is to start wiring the building for a new computer science and electrical engine agency labs. This building ordain have a lot of devices that need to be relateed to the school campus network and we will need a lot of besidesls to do it.First off I think since our building is going to be connected to a lot of students I believe that our best choice of cabling to connect to the building will be fiber-optics. This way the students and professors can access whatever they need as fast as possible from any location on campus. On the inside to save money I would run cat5e cable television services to each individual device. Running fiber-optics to each computer in the computer labs would take a lot of work since fiber is so hard to handle. This will allow them to do all kinds of test involving the net work while not being too budget heavy.Depending on how many floors we have in the building we will need at least one telecommunication room. This is where we will house our otiose frame that holds our servers and networking equipment. We will run the horizontal cables to all of the room wall plates. We will leave the smirch cables to the person in charge of the room arrangements. If at that place are multiple floors in the building we will install backbone cables through the risers so we can have an other telecommunication room for the other floors. Depending on where the plenum is for the floor we will run the horizontal cables under the floor or on top of the false ceiling. If the plenum is over the false ceiling we will need to install a ladder rack and cable trays.We will need a lot of tools to install this network. First off we will need connectors and crimpers so we can connect the cat5 cables to the devices on both sides. Then after we crimp the cables we will have to test the cableswith the wire map testers to make indisputable that all the wires are connected correctly. We will also need a tone and probe so we can figure out where each cable is going, theres a chance we will forget which cable is which and that is why we will need this.When the installation is done we will need at least one laptop to connect to the wall jacks so we can test to see if the connection is live in every room the from there we need to find out how many devices will be connected in each room so we can create a rack for them. After the racks are connected to the wall jacks and once they arrange the devices around the room wecan come back and set up the patch cords to the computers and then the building will be completely wired to the school campuses network.ReferencesHandout NT1310 Physical Networking Unit 4 Key Concepts Cabling and Cabling Systems Textbook- Cabling the complete adopt to Copper and Fiber-Optic Networking 4th Edition by Andrew Olivero / Bill Woodward